US Sunlight SC20 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non US Sunlight SC20. US Sunlight SC20 Installation Guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Table of Contents
1. What is included in this package
2. Tools required
3. Installation instructions
4. Solar Controller settings and operation
Tools Required
- Philips Screwdriver
Pre-Install Check
Please read the entirety of the instructions before proceeding with installation. If your Solar Attic Fan has already been
installed, please make sure the Solar Fan is working properly before installing the Solar Controller
.
INSTALLATION TIPS - Before installing the Solar Controller Box in the attic, test and confirm proper communications
between Controller Box and Remote by following setup procedures.
Installation and
Operation Guide
Tel: 866-446-0966
www.ussunlight.com
A 2 - 8’ Cables
B Controller Box
C Remote Holder
D Remote
E 6 - Mounting Screws
F AC Power Adapter
G 2 - AAA batteries (not pictured)
H 2 - 6” long tie wraps (not pictured)
A
B
C
D
E
F
Setting up Solar Controller
and the Remote
1. Connect AC Power Adapter to the Controller Box. Temperature and relative humidity
will be displayed.
2. The Controller Box has 2 slide switches, the one on the left is for selecting the Radio
Frequency (RF) channel and the one on the right is for selecting the temperature
readout in CelsiusC) or Fahrenheit (°F). Align the RF channel (choice of 1, 2 and 3)
of the Remote with the Controller Box. Both of them must be on the same channel in
order to send and receive signals. Select the desired temperature readout unit.
(fig 1a & 1b)
3. Remove the back panel of the Remote. Insert 2 AAA batteries (included) in the battery
compartment. Replace the back panel of the battery compartment.
4. Test the Remote by pressing the Status button once. This will establish the connection
between the Controller Box and Remote. You will hear a “beep every time the Status button
is pressed. This verifies the Remote and Controller Box RF signals are aligned. If there is
not a beep, check that the RF channel selector is set to the same channel. If there is still
no beep, move both devices to an alternative channel and retry.
fig. 1b
fig. 1a
What is Included in the Box
Vue de la page 0
1 2 3 4 5 6 ... 15 16

Résumé du contenu

Page 1 - Operation Guide

Table of Contents1. What is included in this package 2. Tools required3. Installation instructions4. Solar Controller settings and operationTools

Page 2 - Remote Diagram

Température au grenierNiveau d’humidité au grenierInterrupteur thermiqueCompartiment à pilesMode du ventilateurCourant de la maisonÉnergie solaireÉtat

Page 3 - Standard Installation

1. Apportez l’ensemble complet du Solar Controller, incluant la télécommande et la boîte de contrôle, au grenier.2. Vérifiez et assurez-vous que l’i

Page 4

fig. 14fig. 16 fig. 17fig. 15Installation pour utilisation optionnelle du courant électrique de la maisonSolar Controller utilisera maintenant le pann

Page 5 - Solar Controller Remote

Dos de la télécommande – Interrupteur thermique (ON ou OFF)(marche ou arrêt)L’interrupteur thermique permet à l’usager d’activer ou de désactiver le c

Page 6 - Power Source

Consultez le résumé suivant pour interpréter l’affichage ACL et l’état de marche du ventilateur :Affichage ACL de la télécommandeCourant de la maison

Page 7 - 4 or more fans

Installation à ventilateurs multiples – 3 ventilateurs ou moinsAttribuez un des trois canaux disponibles à chacun des Solar Controllers. Un bip sonore

Page 8 - REGIS T R A T I O N

Garantie limitée du manufacturierU. S. Sunlight Corp. (« le manufacturier ») garantit que certaines composantes de ses produits sont libres de défauts

Page 9 - Guide d’installation

Attic Temperature Attic humidityThermo SwitchBattery CompartmentFan ModeHouse PowerSolar PowerStatusChannel SwitchThermo SwitchInstalling Solar Contro

Page 10 - Schéma de la télécommande

1. Bring the complete Solar Controller Kit, including the Remote and Controller Box, to the attic.2. Check and make sure the Thermo Switch on the ba

Page 11 - Installation normale

fig. 14fig. 16 fig. 17fig. 15Installation with Use of Optional House ElectricityTo utilize the house electricity option with Solar Controller, connect

Page 12 - ) de long. Assurez-vous que

Back of the Remote - Thermo Switch selector (ON or OFF)The Thermo Switch allows the user to engage or disengage the temperature control. U.S. Sunlight

Page 13

Refer to this summary to interpret the LCD display and the fan’s operating status:LCD DisplayHouse PowerSolar PowerFan Operation Summary(Blank) ON ON•

Page 14 - Source de courant

Multiple Fan Setup - 3 or less fansAssign one of the three available channels to each of the Solar Controllers. A beep sound will come from the Contro

Page 15 - 4 ventilateurs ou plus

Manufacturer’s Limited WarrantyU. S. Sunlight Corp. (“Manufacturer”) warrants that certain of its product components are free from defects of workmans

Page 16 - E N REGIS T REM ENT

Table des matières1. Ce qui est inclus dans cet emballage 2. Outils requis3. Instructions d’installation4. Réglages et opération du Solar Controll

Commentaires sur ces manuels

Pas de commentaire